Featured
Gm 10 Bolt Rear End Oil Type
Gm 10 Bolt Rear End Oil Type. First remove the lower bolts around the differential cover and just loosen the top ones. Thats assuming it's a factory gm rear in your car.

But there are far more important areas of concern. 1969 camaro ama specs say capacity is 3.5 pints. But it’s rare to see pinion shafts twist.
But There Are Far More Important Areas Of Concern.
The owners manual calls for 4.5 pints on my 8.5 ten bolt. When checking lubricant level in transmission or rear axle, the unit being checked should be at operating temperature. Can't find it in any service manual.
Many Late Model Differentials Have A Fluid Fill Spec That Is Below The Fill Plug.
12378261, in canada 10953455) meeting gm specification 9986115. Fill it to within half an inch of the bottom of the fill plug hole, and you should be fine. I always buy 3 quarts, because, as bgh alluded to, i always spill some.
If You Fill The Differential To The Point That Fluid Is Running.
In fact, gm issued a service bulletin to bring this to the attention of technicians. The rear end is full of it. Discussion starter · #1 · jul 4, 2008.
With Unit At Operating Temperature The Lubricant Should Be Level With The Bottom Of The Filler Plug Hole.
But it’s rare to see pinion shafts twist. 1969 camaro ama specs say capacity is 3.5 pints. Gear oil is nasty stuff, mostly in smell.
This Is An Older Thread, You May Not Receive A Response, And Could Be Reviving An Old Thread.
Then use a screwdriver to pry open the differential cover allowing the fluid to drain into a bucket or drain pan. Thats assuming it's a factory gm rear in your car. 80w90 gear oil with gm or ford additive will work fine.
Popular Posts
5 Non Rib Bearing Lumbar Type Vertebral Bodies
- Get link
- X
- Other Apps
Types Of Sherwin Williams Interior Paint
- Get link
- X
- Other Apps
Comments
Post a Comment